Many businessmen who buy corn mills do not know how to install the machine. In fact, the installation of a small corn flour mill machine is very simple. The problems pointed out below hope to get everyone’s attention.
①Place the device in a stable and clean place. Before starting the machine, check whether the screws in the sprocket are fixed and whether there is any debris in the cavity. Then inject the appropriate lubricating oil and increase the number of refueling for continuous work. After working for a long time, it is necessary to maintain the bearing cavity of the main shaft of the pulverizer and replace the new lubricating oil after cleaning. The fitting clearance of the newly assembled parts of the corn mill is small, and it is difficult to ensure the uniformity of the fitting clearance. The lubricating oil is not easy to form a uniform oil film on the friction surface to prevent wear, thereby reducing the lubrication efficiency and causing abnormal early wear of the parts. ② Testing equipment is an important equipment for quality management and daily maintenance, which will directly affect daily work. Each location corresponding to each piece of equipment should have corresponding work specifications, operating procedures, and simple troubleshooting methods. Usually, we need to do the following work: clean up the materials at any time, prevent blockages, and ensure the normal operation of the equipment. The mixing is uniform, and the one-time powder does not need to be recycled and crushed, which can ensure the uniformity of the content of each component.